G17 / G22 STANDARD JIG COMPATIBLE WITH POLYMER80 FRAMES

• Standard 4 Hole Finishing Jig
• M3 and M4 Drill Bits
• M3 and M4 Drill Bit Guides
• Guide Rod Channel Jig - Uses 7/16 Drill Bit not included
• (4) Screws to secure jig to frame - Uses 2.5mm Allen Wrench not included
• The frame in the picture is for reference only and is NOT included

Precision Jig Installation:

✅ Install the Jig Plates

• Affix both the left and right jig plates securely to the frame.

✅ Prepare the Left Jig Plate

• Insert four (4) nuts into the designated recesses on the left jig plate.

✅ Prepare the Right Jig Plate

• Thread four (4) screws into the right jig plate.
• Note: The screws will not fall freely; the holes are undersized to ensure precise alignment.
• Hold both plates firmly together while threading.
• Do not fully tighten at this stage.

✅ Tighten the Assembly

• Once the screws are threaded into the nuts, gradually tighten all screws, rotating each one full turn at a time.
• Continue in an X pattern until the plates are firmly pressed together.
• Caution: Avoid overtightening.

✅ Secure the Frame

• Clamp the frame and jig securely to the drill press or workstation.
• Ensure the assembly is fully stabilized.

✅ Prepare the Drill Bit

• Insert the drill bit into the guide; a tight fit is normal.
• Adjust the bit until approximately 1/8 inch extends below the guide.

✅ Verify Alignment

• Confirm that the drill guide sits flat against the jig before drilling.
• Use the appropriate Guide for each hole. Guide 3 should be used for the holes marked "3" etc.
• Drill carefully, completing one side at a time. Do not drill straight through.

✅ Drilling Best Practices

• Drill Press: Ensure the table is perfectly level.
• Hand Drill: Keep the drill perfectly vertical.
• Tip: Enlist an assistant to help verify left-to-right and front-to-back alignment.

✅ Guide Rod Channel

• Insert the jig into the channel.
• Tape the jig securely in place.
• Insert a 7/16" drill bit. A tight fit is normal.